Type: Urethane resin system/3 component baking and drying type

Features: Even if dried at low temperatures on glass, there will still be adhesion, which can also be tested through various physical properties; Excellent smoothness and luster.

Dilution solvent: Standard solvent T-980

Cleaning solution: T-31

Printing: Polyester screen T250-420 mesh

 

Additive mixing

Mixing ratio: HF GV3 710, other colors: A Hardening agent: CARE 183=100:15:2/HF GV3 120: A Hardening agent: CARE 183=100:10:2

Drying time: recommended at 120 ℃ × Over 30 minutes (Note 1

 

Other

(Note 1: When the alcohol resistance is poor, please maintain it at 120 ℃) × Dry for over 40 minutes

• ・Additives should be mixed and stirred according to the recommended ratio. If viscosity needs to be adjusted, please use a diluent for adjustment. The viscosity of the mixed inks will gradually increase after 3 hours at room temperature. (Suggested dilution)
• ・If bubbles are generated during printing, please add CARE 111. When the printability of the material is poor and oil scattering occurs, resulting in pinholes, the diluent solvent should be changed to T-979, and then the extinction agent should be added to effectively suppress the occurrence of pinholes.
• ・When using high mesh screen printing and producing fine substances on the printing surface, please reduce dilution or use low mesh screen printing.
• ・The performance of the HF GV3 series may decrease due to the influence of external environment. At this time, CARE 183 up to 1% can be added for adjustment.
• ・Inks that has been stored for too long must be confirmed for performance before use.
• ・The service life is 7 hours. Do not use if it exceeds 7 hours.
• ・If you want to improve water resistance or experience uneven color, please replace CARE183 with CARE182 for use.

 

Reference materials (the performance table is our company's test values, not the guaranteed performance values)

 

Properties

※ Note 1: When the resistance value is above the 13th power, it may fluctuate depending on the surrounding environment (temperature or humidity, etc.), please be aware.

 

Test conditions

Inks: HF GV3 710 black

Material: Reinforced glass (3 types)

Printing mesh: Polyester 420 mesh

Scraper hardness: Urethane resin medium hard

Printing: Hand printed

Mixing ratio: HF GV3 710: A Hardening agent: CARE183=100:15:2 Dilution rate: 10%

Drying ： HF GV3: 120℃×30min