The PO-XF series ink is suitable for printing on pre treated polyolefins such as polyethylene and polypropylene, and is also suitable for various metals (anode and drawn parts), coatings, wood, and paper. Adding a hardener as a two-component ink has excellent water resistance and solubility.
Single and two-component screen printing ink.
Suitable for the following materials: pre treated polyethylene, polypropylene; For various metals, coatings, wood, and paper.
The ink layer has high gloss and good transparency.
After adding a hardener, the physical properties of the ink layer are better, such as water resistance and solubility.
The weather resistance of the ink can reach 7-8 levels, and it has excellent adhesion to oxygen electrodes and drawn parts. As a single component ink, the evaporation and drying speed is fast.
Metal class: 150 ℃ for 30 minutes; Plastic, paper, wood, etc. should be stored at 60-80 ℃ for 30 minutes, and their physical properties should be tested after being left for 24 hours.
PO-XF can be used as a single component ink or as a two-component ink with the addition of 10% ZH hardener (yellow color, short usage time) or ZH/N/00 hardener (lighter color than ZH).
Use VD20, VD60, and VZ25 as diluents, with an addition amount not exceeding 20%.
As a two-component ink, the usage time is approximately 6-8 hours; If the color is metallic, the usage time will be reduced.
Use URS, URS3, or VD40 as cleaning agents
Previous item:TP 300 Series
Next item:None